www.neumann.com
Forums:
Email:









Forums / Archive / Thread
re-assembly of TLM-103
Author: Posted by Bob
Date: 03/19/2004
Hello--I had a TLM-103 sustain some minor damage after falling from a stand mount. My original thought was to replace the dented windscreen, but this proved to be very costly so I elected to remove it and carefully bend out the dented areas. It actually doesn't look too bad! However, in so doing, I inadvertently removed the push-on connector and for the life of me can't figure out which way it goes back on (doh!).
My guess is hooking it up backwards would be Bad, as the 48 volt phantom supply would be reversed. Can anyone please tell me which way it goes on--wire side facing the housing, or facing the capacitors? (Usually these connectors aren't reversible, but this one is.) Your help is much appreciated. Thanks--Bob  
Posted by Bob
03/19/2004
 
Posted by Uwe Sattler, Neumann|USA
03/19/2004
 
Posted by Bob
03/19/2004