www.neumann.com
Forums:
Email:









Re: KM 56 power supply and other concerns
Author: Martin Schneider/Neumann
Date: 11/21/2006
Dear Mr. Head,

you can check the voltages with a standard voltmeter, WITH the mic connected, as David Satz mentioned. 4.2V max for the filament, 120 V max for the anode / capsule. Slightly lower voltages are fine; with relevantly higher voltages immediately disconnect the mains, and adjust the supply (internally) to lower voltages.

Best regards,
Martin Schneider / Neumann Mic. Development  
 
Reply
Richard Head
11/19/2006
David Satz
11/19/2006
Richard Head
11/20/2006
Martin Schneider/Neumann
11/21/2006
Donagh Long
11/23/2006
Martin Schneider/Neumann
11/23/2006
Donagh Long
11/26/2006
Klaus Heyne
11/26/2006
Donagh Long
11/30/2006
Klaus Heyne
12/01/2006
Richard Head
11/28/2006
Klaus Heyne
11/28/2006
Richard Head
11/29/2006
Martin Schneider/Neumann
11/29/2006
Klaus Heyne
11/29/2006
Evan Lorden
04/07/2013
Martin Schneider/Neumann
04/08/2013
Uwe Sattler/NeumannUSA
04/08/2013
Evan Lorden
04/08/2013