I had a few questions on the numbering of contacts cable mikrfona neumann U 67. The first question. The diagram is drawn, that pitenie 210 volts should be at 5 contact microphone the microphone. And this PIN is connected, the lines С14 disabling the microphone. I have the microphone impedance is connected to 14 with 2 pin connector on the microphone. I'm confused. Apparently were different editions of this microphone. In the power supply, as in the diagram only dual voltage (210 Wold and 6.3) would like to know how to properly raspa‚t′ cable to not burn rare microphone!! Hope quick response!!! Konstantin.