www.neumann.com
Forums:
Email:









Re: How to connect a Neumann C3FI signalling light ?
Author: Martin Schneider/Neumann
Date: 10/03/2012
Hello,

there were over 100 (!) different configurations of CF3 & CF35.

Simplest thing is to measure between all pins, and check where you get 0 ohms, and where you get an open contact, and where you have the very few ohms of a light bulb.

Then, connect 6 Volts, and see if the lights work.

Attention: There were 6, 12 and 24 volt versions!

To open, screw the small screws at the XLR *in*wards (not outwards), just a tiny bit. Then you should be able to carefully pull out the bottom with XLR from the housing.

Best regards,
Martin Schneider / Neumann Mic. Development  
 
Reply
j-philippe auger
10/02/2012
Martin Schneider/Neumann
10/03/2012
  Re: 
Uwe Sattler/NeumannUSA
10/03/2012